Videx VK4K Series Installation Handbook page 18

VK4K/6458 Series "6 wire Bus" videokit
6400 Series
2
Fig. 1
Fig. 4
1. In order to install the videophone, it is necessary to remove the cover, which contains all the electronics, from the base: press
lightly on the right part of the videophone and simultaneously pulling outwards the left part as shown in Fig. 1.
2. Put the base of the unit on the wall at approx 135cm from the finished floor to match the points for the fixing holes "A" (Fig. 2)
remembering that the wires "D" (Fig. 3) must be fed through the large hole "E" (Fig. 3). If you use the flush mounting box 503,
embed it into the wall vertically at approx. 140cm from the finished floor and the base.
3. Following Fig. 3, make the holes "A", insert the wall plugs "B" and fix the base with the screws "C" feeding the wires "D"
through the hole "E". If you have used the box 503, fix the base to the wall through the holes "F" using the screws "C".
4. As shown in Fig. 4, connect the wires to the removable terminals following the provided installation diagram. Connect the terminal
blocks to the electronics contained in the cover as shown in Fig. 5. Test system before closing.
Contrast and hue trimmers can be adjusted only if the videophone is open. To activate the display and see changes use the
"Camera Recall" function by pressing
Note: while testing the system, it is advisable to hold the cover with your hand.
5. Once testing is complete and all the necessary adjustments are made, close the unit as shown in Fig. 6: first hook in the right
part and then the left part until you hear a click.
VK4K/6458 Series - Installation handbook
Wall mounting instructions
1
Fig. 2
Fig. 5
button.
Fig. 3
Fig. 6
18
B
D
A
C
F
E
F
2
66251410-EN - V 3.4 - 31/08/16
B
A
C
1