Installing A Serial Port - Fujitsu CELSIUS J550 Operating Manual

Installing a serial port

Depending on the configuration level of your device, there may be installation
openings on the rear panel, intended for serial ports.
► Remove the casing cover (see chapter
If no port has been installed yet, the installation openings are covered by a spring
metal cover or a break-out plate. Do not throw away the spring metal cover. In
order to comply with the electromagnetic compatibility (EMC) regulations, you
must refit the metal cover if you remove the serial port again.
► Keep the clips (1) pressed and push the metal plate out of the casing from the inside (2).
► Position the serial port on the inside of the device at the appropriate place (3).
Fujitsu
"Removing the casing cover", Page
System expansions
35).
1
2
1
3
71