System expansions
Removing a chipcard reader
3
Pull the cable off the chipcard reader (1) and off the connector for the chipcard reader on the
system board (see the Technical Manual of the system board).
Press on the clip (2).
Pull the chipcard reader in the direction of the arrow (3).
Lift the chipcard reader out of the system unit (4).
Installation opening for 2
An installation opening for the 2
means no board slot is occupied.
Insert a screwdriver into the opening and break out the pre-stamped installation opening by
moving back and forth.
42
2
1
nd
serial port is provided on the back of the casing. As a result, this
4
nd
serial port
A26361-K520-Z100-4-7619