STATus:OPERation[:EVENt]?
Comments
Example
STATus:PRESet
84 HP E1476A Switchbox Command Reference
STATus:OPERation[:EVENt]?
Status Group) are set. The Event Register indicates when there has been a time-
related instrument event.
•
Setting Bit 8 of the Operation Status Register: Bit 8 (scan complete) is set to
1 after a scanning cycle completes. Bit 8 returns to 0 (zero) after sending the
STATus:OPERation[:EVENt]?
•
Returned Data after sending the
Command: The command returns "+256" if bit 8 of the Operation Status
Register is set to 1. The command returns "+0" if bit 8 of the Operation Status
Register is set to 0.
•
Event Register Cleared: Reading the Event Register with the
STATus:OPERation:EVENt?
•
Aborting a Scan: Aborting a scan will leave bit 8 set to 0.
•
Related Commands:
Reading the Operation Status Register After a Scanning Cycle
STAT:OPER?
read the register value
STATus:PRESet
affects only the Enable Register by setting all Enable Register bits
to 0. It does not affect either the "status byte" or the "standard event status".
does not clear any of the Event Registers.
returns which bits in the Event Register (Operation
command.
STATus:OPERation[:EVENt]?
command clears it.
[ROUTe:]SCAN
Return the bit values of the Operation
Status Register.
+256 shows bit 8 is set to 1;+0 shows bit
8 is set to 0.
PRESet
Chapter 3