Table of Contents
Advertisement
STATus:OPERation:CONDition?
STATus:OPERation:ENABle
Parameters
Comments
Example
STATus:OPERation:ENABle?
Comments
Example
Chapter 3
STATus:OPERation:CONDition?
Operation Status Group. The state represents conditions which are part of the
instrument's operation. The "SWITCH" driver does not set bit 8 in this register (see
STATus:OPERation[:EVENt]?
STATus:OPERation:ENABle <unmask>
recorded in the Event Register to send a summary bit to the Status Byte Register
(bit 7). For Multiplexer Modules, when bit 8 in the Operation Status Register is set
to 1 and that bit is enabled by the
Status Register is set to 1.
Parameter
Parameter
Name
<unmask>
numeric
•
Setting Bit 7 of the Status Register: S
bit 7 of the Status Register to 1 after bit 8 of the Operation Status Register is
set to 1.
•
Related Commands:
Enabling Operation Status Register Bit 8
STAT:OPER:ENAB 256
STATus:OPERation:ENABle?
Status Group) are unmasked.
•
Output Format: Returns a decimal weighted value from 0 to 65,535
indicating which bits are set to true.
•
Maximum Value Returned: The value returned is the value set by the
STAT:OPER:ENAB <unmask>
weighted value used in this module is 256 (bit 8 set to true).
Query the Operation Status Enable Register
STAT:OPER:ENAB?
returns the state of the Condition Register in the
).
sets an enable mask to allow events
STATus:OPERation:ENABle
Type
Range of Values
0 through 65,535
TATus:OPERation:ENABle 256
[ROUTe:]SCAN
Enable bit 8 of the Operation Status
Register to be reported to bit 7 (OPR) in
the Status Register.
returns which bits in the Event Register (Operation
command. However, the maximum decimal
Query the Operation Status Enable
Register.
HP E1476A Switchbox Command Reference
command, bit 7 in the
Default
Value
N/A
sets
83
Advertisement
Table of Contents
