To set the data acquisition mode to N Sample Acquisition mode
To set the data acquisition mode to N sample acquisition mode, you need to configure the
following parameters:
In Configurations tab
Channels:Select the number of channel to be enabled.
Trigger:Select Analog threshold trigger as the trigger type.
Sample Rate:Specify a value of the sample rate from 0 to 128000.
Sample Count:Specify a value of the target sample from 0 to 15000000. 0 means keep
collecting data until stop command is received.
In Analog Setting tab
High Level/Low Level:Specify a value of the analog threshold trigger high/low level from
+10 to -10.
AI Mode:Select the analog threshold trigger conditional and specify a value of the
left/right count.
PET-AR400 User Manual
The Analog Setting tab will be displayed when
the Analog threshold trigger is selected
V1.0.0
Top
P.29