Table of Contents
Advertisement
Modifying the Hoses, Installing the
Refer to Figure 8 on page 12 for an illustration of the modified
coolant system.
☐
Roll the OEM anti-abrasion mesh up towards the radiator side quick connect as
this will be retained on the hose.
☐
From the radiator side of the hose, measure 5 1/4 in along the outside radius
towards the center of the hose and mark with a grease pen (Figure 2).
To radiator
☐
From the radiator side of the hose, measure 6 3/4 in along the outside radius
towards the center of the hose and mark with a grease pen (Figure 3).
To engine
VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: kb.vmacair.com
Cooler
Figure 2 — Lower radiator hose modification
6 3/4 in
Figure 3 — Lower radiator hose modification
5 1/4 in
90°
9
Advertisement
Table of Contents
