Part 3: Installing the Cooler and
3.1 Installing the Oil Cooler
□
Place the cooler on the passenger side frame rail so that the
brackets fit around the anti-roll bar bracket and the vertical inside
face of the cooler bracket is flush with the frame rail.
□
Loop the retaining cables from the bottom holes around the
frame and back through the top holes (Figure 3.1).
□
Install a washer and spacer on the cable closest to the rear of
the truck and a washer on the cable closest to the front of the
truck. Thread nuts on each cable and tighten them. Install and
tighten a second nut to act as a lock.
Spacer
VMAC – Vehicle Mounted Air Compressors
Toll Free: 1-800-738-8622
Fax: 1-250-740-3201
Compressor
System V900077
To Engine
Anti-roll bar
bracket
Cable straps
Figure 3.1
To Radiator
Front
Passenger
side frame
rail
9