Part 3: Installing The Cooler, Bracket And Compressor; Installing The Oil Cooler - Vmac VR70 Installation Manual

Part 3: Installing the Cooler,
Bracket and Compressor

3.1 Installing the Oil Cooler

□
Insert the supplied cooler mounting bolts through the holes in the
front body support brackets under the radiator.
□
Place the cooler in position over the bolts, with the hoses and oil
fittings facing to the rear of the van (Figure 3.1). Install the nylon
locking nuts and tighten them securely.
□
Loosen the hose clamps on the cooler end of the radiator hoses
so that they can be adjusted and positioned.
□
Install the end of the driver side hose onto the OEM diverter
valve (lubricate the fitting or the hose to make installation easier).
Position the hose for best fit and tighten the clamps.
□
Install the passenger side hose on the radiator fitting, position
the hose for best fit and tighten the clamps.
Cooler to radiator hose
Radiator
support
bracket
VMAC – Vehicle Mounted Air Compressors
Toll Free: 1-800-738-8622
Fax: 1-250-740-3201
Cooler to diverter hose
Figure 3.1
Radiator
support
bracket
11