Lincoln Electric Aspect 230 DC Operator's Manual page 23

ASPECT ® 230 DC
Appendix
A.1 Volt and Amp meter display while welding and idle.
While welding, the machine will show actual voltage and amperage on the meters. When the welding arc is extinguished, the meters will
display (and flash) the final voltage and amperage of that weld for 5 seconds.
A.2 Green Mode
(Show the V and A displays with GRN MODE)
Green mode is a feature that puts the machine in a standby condition after 10 minutes of inactivity.
• Output is Disabled.
• Fans Change to a Low Speed.
• LEDs Switch Off – Only the Power ON LED Remains Lit.
• A hash line will illuminate across the display.
This feature will reduce the amount of dust and dirt that is drawn into the machine and will lower the machines power consumption.
To exit Green Mode, simply press the TIG remote trigger or any button on the front of the machine.
®
NOTE: If a Cool Arc machine is connected to the Aspect
flow, Green Mode must first be exited.
A.3 2-Step Trigger with Restart Sequence
2-Step trigger with restart can be enabled in setup menu "GTAW" by switching 2RST to ON. If 2RST is ON, a TIG mode is selected,
and 2-step is selected on the output section of the machine, the following sequence will occur.
This sequence is the same as 2-step, except when the switch is pressed while in final slope the welding current will ramp up again
and resume. This process can be repeated as many times as necessary. When finished welding, simply release the trigger and allow
the finishing current to end and the output to switch OFF followed by the post flow time.
Figure B.25
----
®
230 DC, entering Green Mode will stop the coolant flow. To resume coolant
(1) (2)
B-11
150
OPERATION