Planar Dome E2 User Manual page 16

Main
(Video 1)
connector
6 | Dome EX Display
Install Display Controller
Before you install the display controller, make sure your display
system is set up in a well-ventilated location with an adequate
amount of space. Excessive heat cannot dissipate when display vents
are blocked. Make sure a grounded AC outlet is within easy reach.
MX2/MX3 display controller
To install controller board
1 Turn off your computer and peripherals. Disconnect all the cables.
Leave the power cord plugged into the grounded outlet.
2 Remove the computer cover and then the blank bracket from
the available PCI slot.
3 Insert the display controller into the slot, align the connector pins,
and press the board down until it is firmly seated.
4 Secure the mounting bracket, and reattach the computer cover and
the peripherals.