Table of Contents
Advertisement
5
or
to the required channel. Press the Menu Select button directly below Sel .
The display shows Channel updated.
6 Press the Menu Select button directly below Exit to return to Home screen.
6.2.8.3
Deleting a Channel in the Dynamic Zone
Prerequisites:To perform this operation, the radio must be in the Dynamic Zone.
Procedure:
1
or to ZnPr then press the Menu Select button directly below ZnPr to enter Program Zone
screen.
The display shows the dynamic channels list.
2
The display shows Channel deleted screen.
3 Press the Menu Select button below Exit to return to Home screen.
The Home screen shows <Dynamic Zone Channels>.
If the channel deleted is the Home channel, the Home screen shows <Zone Name>"Blank".
6.3
Multiple Control Head Features
This feature allows your transceiver to control the combinations of control heads on APX Mobile.
You can use the Controller Area Network (CAN) cables to connect in any configuration that does not
exceed 131 feet. For further information, refer to the following Installation Manuals:
•
6878215A01 APX Mobile Radios and Control Heads Installation Manual
•
MN003109A01 APX 8500 Mobile Radio Installation Manual
•
MN005720A01 Enhanced Single Band Mobile Radio Installation Manual
The Multiple Control Head (MCH) feature consists of two modes that can be programmed through
Customer Programming Software (CPS):
•
All Active mode
•
One Active mode
6.3.1
Setting the ID of the Initial Control Head
When and where to use:This feature allows you to set up the control head in the Front Panel
Programming (FPP) mode. During the setup, the control heads are defined as Control Head Number
1, Control Head Number 2, Control Head Number 3, and Control Head Number 4.
Procedure:
1 Power off the radio by pressing the Power button.
2 Press and hold the left-most Menu Select button and the emergency button simultaneously.
MN006147A01-AE
Chapter 6: Advanced Features
49
Hide quick links:
Advertisement
Table of Contents
