Subscribe to Our Youtube Channel
Related Manuals for Beninca BISON 30 OTI
Summary of Contents for Beninca BISON 30 OTI
- Page 1 L8542968 07/2012 rev 0 BISON 30 OTI UNIONE NAZIONALE COSTRUTTORI AUTOMATISMI PER CANCELLI, PORTE SERRANDE ED AFFINI...
- Page 4 MIN = 161mm MAX = 171mm MIN = 8mm MAX = 18mm ≈2 mm...
- Page 5 ø 5,5 mm...
- Page 6 CARTER-GND FILTER 400 Vac/3PH...
- Page 7 It is hereby stated that the product automatic system 230 Vac for sliding gates BISON 30 OTI is compliant with provisions set forth in the following EC Directives: - DIRECTIVE 2004/108/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 15 December 2004, on the harmonisa- tion of the laws of Member States relating to electromagnetic compatibility and which cancels Directive 89/336/EEC, according to the following harmonised regulations: EN 61000-6-2:2005, EN 61000-6-3:2007.
-
Page 8: General Information
3000 kg max weight. If the rack is already installed, a fitting base, raised with respect to the floor, should be required. However, it is not BISON 30 OTI is equipped with: advisable to lower the fitting surface. - anti-crash electronic device (encoder) If the rack used is the model RI.M6Z, the edge of the plate... - Page 9 It is hereby stated that the product automatic system 230 Vac for sliding gates BISON 30 OTI is compliant with provisions set forth in the following EC Directives: - DIRECTIVE 2004/108/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 15 December 2004, on the harmonisa- tion of the laws of Member States relating to electromagnetic compatibility and which cancels Directive 89/336/EEC, according to the following harmonised regulations: EN 61000-6-2:2005, EN 61000-6-3:2007.
- Page 10 3000 kg max weight. If the rack is already installed, a fitting base, raised with respect to the floor, should be required. However, it is not BISON 30 OTI is equipped with: advisable to lower the fitting surface. - anti-crash electronic device (encoder) If the rack used is the model RI.M6Z, the edge of the plate...
-
Page 11: Manual Operation
Should the gear motor height must be adjusted, proceed WIRE DIAGRAM as follows: Figure 13 shows the cables to the preset for the installation - back-off nuts D of the gear motor and the main accessories. - back-off nuts W As regards the wire connection of the automatic system and - adjust the 4 grub screws K by using a 6mm hexagon key.
Need help?
Do you have a question about the BISON 30 OTI and is the answer not in the manual?
Questions and answers