Table of Contents
Advertisement
Initial Camera Setup - continued
-
Set Review for "5 seconds" and Drive Mode to "Single Shot."
-
Set Review Info to "Off" and IS Mode to "Continuous."
-
Set DR Correction to "Off" and AWB White Balance to "Auto."
-
Set Shooting Mode to "Single Shot
-
Set ND Filter to "Off" and Still Image Aspect Ratio to 4:3.
-
Set Image Type to "JPEG 12M" and Image Compression to "L."
-
Set ISO to "80" and Metering to "Center Weighted Avg
-
In the Power Saving Menu, set Auto Power Down to "Off" and Display
Off to "3 min."
-
Raise the camera flash before placing camera in housing when NOT
using external strobes. DO NOT attach the housing Hotshoe Connector.
Set Flash to "Flash always fires
-
When using external strobes, DO NOT raise the camera flash. Instead,
attach the housing hotshoe - page 10, diagram A.
-
Set Macro mode
is overexposed, use "-" Flash Exposure Compensation
and/or back away, zoom in, and then reshoot.
Notes:
TTL Flash is NOT available when camera is in "M" Manual mode. There
is no TTL flash even with Canon's own flash in the camera "M" mode.
Manual power settings can be selected in the "Flash Control" section of
the camera menu. The strobe should still be left in TTL mode to take
advantage of this feature.
Leave the housing hotshoe disconnected when using ONLY the camera
flash and no external strobes, or when using an EV manual
controller. If using an EV controller in "M" Manual mode, set the EV
controller to "non-Pre-flash."
When multiple exposure (continuous shooting) mode is used with a
non-TTL flash, the external flash will not fire.
6
."
to "On" when shooting close-up. If the image
."
."
Advertisement
Table of Contents
