Preparation
This product has been water pressure tested at the factory and is depth
rated to 200ft (60m). Thoroughly inspect and immerse the empty
housing completely in water before installing a camera. If any fogging
occurs or droplets of water enter the housing, do not install a camera.
Clean the main housing o-ring and retest to make sure that it is
watertight. Refer to the Troubleshooting section, page 21.
Please read your camera manual thoroughly to have a full
understanding of each camera function.
If you are new to underwater photography, be sure to read the Photo
Tips section, page 20.
Initial Camera Setup
-
Insert a fully charged battery. Due to the power required to operate the
camera and LCD screen, start each dive with a fully charged camera
battery.
-
Insert and format a SD or SDHC memory card.
-
Set camera date and time.
-
Set Mode Dial to "Av" Aperture Priority.
-
Set AF Frame to "Flexizone" and Digital Zoom to "Off."
-
Set AF-Point Zoom to "Off" and Set Servo AF to "On."
-
Set Continuous AF to "Off" and AF-assist Beam to "Off."
-
Set MF-Point Zoom and Safety MF to "On."
In the Flash Settings Menu set Flash Mode to "Auto", Shutter Sync.
-
to "1st-curtain", Red-eye Corr. and Red-eye Lamp to "Off", and
safety FE to "Off."
-
Set Spot AE Point to "Center" and Safety Shift to "Off."
(before placing camera in housing)
5