Table of Contents
Advertisement
J.3 Control Panel Operation
All of the control panel function buttons and mode icons can be viewed in Figure 8.
Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The backlight on the power switch will
automatically turn off after 20 seconds of inactivity.
Display – The display is a high efficiency LCD with a built-in backlight. After 20 seconds of inactivity, the display switches off. Touching any button automatically changes
the display to full brightness.
There are three control push buttons on each side of the display.
SYSTEM
FAN MODE
Cycles between
Sets fan to either:
AUTO, HEAT,
- Cycle automatically
COOL, or FAN
- Run continuously
ONLY
(if equipped)
Figure J.3.1
MODE
Cycles between
COOL, HEAT, FAN
ONLY or -AUTO-
Figure J.3.2
(if equipped)
FAN
Sets fan to either:
- Automatically cycle
- Continuously run
FAN SPEED
TEMPERATURE
Sets fan speed:
Increment UP
LOW, MED,
HIGH or AUTO
TEMPERATURE
(if equipped)
Increment DOWN
COOL HEAT FAN ONLY
-AUTO-
Automatically switches
between cool & heat
FAN SPEED
2 DIGIT DISPLAY
Sets fan speed:
Shows Setting for:
LOW, MED, HIGH, OR MAX
- Set Point (Temperature)
(Actual settings are
- Clock (AM/PM)
model dependant)
J. STARTUP AND OPERATION
TIMER
IR WINDOW
Turns ON or OFF
Do not block
DISCONNECTED
CONTROL
WI-FI OPERATING
FROM POWER BOARD
LOCKED
STATE
FILTER
TIMER
Check / clean
shows on or off
ON / OFF
Turns unit on/ off
31
Advertisement
Table of Contents
