Table of Contents
Advertisement
C.6 Cord Routing Change
Unplug unit.
WARNING
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner's
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Always plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
For convenience and optimum appearance, the direction that the power cord
exits the unit may be changed from left to right by following the procedure below.
Select the exit location on the left or right based on proximity to the power outlet.
ELECTRICAL
CONTROL
PANEL
Figure C.6.1
STEP 1 Remove the 3 screws as shown from the electrical control panel.
Save to reinstall later.
ELECTRICAL CONTROL
PANEL SCREWS (3)
Figure C.6.2
26
C. INSTALLATION OF THE UNIT
STEP 2. Carefully pull out electrical control panel 1", but not all the way.
Figure C.6.3
STEP 3. Pull electrical cord strain relief downward until free and rotate 90
degrees to the right.
90°
ELECTRICAL CORD
STRAIN RELIEF
Figure C.6.4
STEP 4. Push electrical cord strain relief back upward into the electrical control
panel.
ENSURE THE ELECTRICAL CORD STRAIN RELIEF IS FLUSH
WITH THE TOP OF ELECTRICAL CONTROL PANEL.
Figure C.6.5
Advertisement
Table of Contents
