Steps
1. Align the Thunderbolt PCIe card with the expansion-card slot on the system board.
2. Using the alignment post, connect the Thunderbolt PCIe card to the connector and press down firmly. Ensure that the
Thunderbolt PCIe card is firmly seated.
3. Route the Thunderbolt PCIe through the routing guide on the chassis.
4. Connect the Thunderbolt PCIe cable to the connector on the system board.
5. Close the PCIe door, locking it into position.
Next steps
1. Install the
air
shroud.
2. Install the
side
cover.
3. Follow the procedure in
Removing the wireless card
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
air
shroud.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
77