Shoulder Pads - Britax romer EVOLVAFIX User Manual

1. Pull the cover 1 forwards.
INFO The cover 1 is fastened with press buttons.
2. Remove the cover 1 from the harness buckle 2.
3. Loosen the front loops 3.
4. Loosen the side cover edges 4.
5. Pull the cover 1 up and off.
7.2.3 Clean cover
You can remove the following covers and wash them
in the washing machine:
Cover of the headrest.
u
Seat cover.
u
Cover of harness buckle.
u
Cover of the SecureGuard.
u
Note the instructions on the cover's washing label.
u
Wash the cover at 30 °C with a mild detergent on the
u
washing machine's fine wash programme.
You can remove the shoulder pads and wash them with
u
like warm soapy water.
You can clean the plastic parts and straps with soapy
u
water.
Do not use strong cleaning agents (such as solvents).
u
7.2.4 Attach cover
Risk of injury due to missing seat cover
The seat cover is an integral safety component of the
child seat. If the seat cover is not used, this may lead to
serious or even fatal injuries.
Never use the child seat without the correct seat
u
cover.
Only use the original Britax Römer replacement seat
u
cover.
Replacement seat covers are available from your re-
u
tailer.
To fit the cover again, follow the steps in the reverse or-
u
der.
Risk of injury due to twisted straps.
Twisted straps have a negative impact on the protective
function.
Ensure that the straps are tight and not twisted.
u
Ensure that the straps are fitted correctly in the belt
u
slots of the cover.
IP10199 | 1.1 | 2000038326
WARNING
WARNING
EVOLVAFIX | BRITAX RÖMER
7.3

Shoulder pads

7.3.1 Remove shoulder pads
1
Shoulder straps
2
Adjustment button
3
Shoulder pads
1. Loosen the child seat (see "Loosen child seat A (76 –
105 cm)", page 10).
2. To loosen the belt, press the adjustment button 2 and
pull both shoulder straps 1 forwards at the same time.
The shoulder pads are not connected to the shoul-
der straps. If you pull on the shoulder pads, the
belt is not loosened. Only pull on the shoulder
straps.
3. Open the two shoulder pads 3.
4. Place the TopTether 4 forwards above the seat.
5. Unhook the pocket 5 up and off.
6 Shoulder strap
7
Belt loop
8
Plastic web
6. Extend the shoulder straps 6 slightly so that you can
see the belt loops 7 of the shoulder pads 10 under-
neath.
7. Unhook the belt loops 7 from the plastic web 8.
8. Pull the shoulder pads 10 forwards our of the
belt slots 9.
4
TopTether
5
Pocket
6
9
10
9 Belt slot
10
Shoulder pads
7
8
10
24