Settings; Adjust Headrest - Britax romer EVOLVAFIX User Manual

3

Settings

3.1

Adjust headrest

The headrest setting depends on the type of securing
(see "Fastening type A and B", page 7).
3.1.1 Set headrest A (76 – 105 cm)
1
2
1
Headrest
2
Adjustment button
1. Check that the headrest 1 is adjusted to the size of the
child.
If the exit for the shoulder straps is at the shoul-
der height of the child, the headrest is positioned
correctly. A difference of up to 3 cm is permitted.
However, Britax Römer recommends position-
ing the exit of the shoulder straps at the shoulder
height of the child.
If the headrest is not positioned correctly, per-
u
form the following steps.
2. To loosen the belt, press the adjustment button 2 and
pull both shoulder straps 3 forwards at the same time.
The shoulder pads are not connected to the shoul-
der straps. If you pull on the shoulder pads, the
belt is not loosened. Only pull on the shoulder
straps.
3. Keep the release button 4 pressed and slide the
headrest 1 to the correct shoulder height.
4. Check that the headrest 1 is locked correctly in place
by pushing the headrest 1 down.
P Headrest 1 is adjusted to the size of the child.
P Headrest 1 is locked in place.
IP10199 | 1.1 | 2000038326
3
4
3
Shoulder straps
4
Release button
EVOLVAFIX | BRITAX RÖMER
3.1.2 Set headrest B (100 – 150 cm)
1
1
Headrest
The headrest has a lock. This lock corresponds to a
height of approx. 125 cm You can unlock the upper
area from approx. 125 cm to 150 cm (see "Unlock up-
per area", page 5).
1. Check that the headrest 1 is adjusted to the size of the
child.
If the headrest is two finger-widths above the
shoulder height of the child, the headrest is posi-
tions correctly.
If the headrest is not positioned correctly, per-
u
form the following steps.
2. Keep the release button 2 pressed and slide the
headrest 1 to the correct shoulder height.
3. Check that the headrest 1 is locked correctly in place
by pushing the headrest 1 down.
P Headrest 1 is adjusted to the size of the child.
P Headrest 1 is locked in place.
3.1.3 Unlock upper area
1
Pocket
2
2
Release button
2
Switch
5