Britax romer EVOLVAFIX User Manual page 9

1
4
1 Pocket
2 Snap hooks
3 Belt
1. Hang the snap hook 2 of the TopTether from the rear of
the child seat.
2. Take the belt 3 from the pocket 1.
3. Place the belt 3 across the child seat.
4. Place the child seat on the selected car seat in the di-
rection of travel.
5. Adjust the angle of the backrest to the car seat.
The gap between car seat and child seat should be
as small as possible.
6. Extend the belt 3 by pushing the metal tongue 4 from
belt 3 and pulling on the snap hook 2.
7. Pass the snap hook 2 centrally between the bars of the
vehicle headrest 5.
If the headrest is integrated in the car seat, pass
the snap hook and the belt past the headrest. Use
the side closer to the anchor point of the vehicle.
8. Hook the snap hook 2 into the vehicle's anchor point 6.
IP10199 | 1.1 | 2000038326
3
2
4 Metal tongue
5 Bar of the vehicle
headrest
6 Anchor point
EVOLVAFIX | BRITAX RÖMER
Depending on the vehicle, the anchor point is on
5
the car seat or in the boot, for example. Note and
observe the vehicle handbook.
P The snap hook 2 is secured with the anchor point.
P The TopTether is ready.
4.2.4 Fastening the ISOFIX
6
1 1
1
ISOFIX locking arms
2 Release button
1. Press the locking button 4 and the release button 2 to-
gether and slide the ISOFIX locking arm 1 out as far as
possible.
3
3
4
1 2
3
ISOFIX indicator
4 Fastening button
3
9