Table of Contents
Advertisement
• During a semi-automatic maneuver, if the driver
touches the steering wheel after being instructed to
remove their hands from the steering wheel, the
system will cancel, and the driver will be required to
manually complete the parking maneuver.
• The system may not work in all conditions (e.g.
environmental conditions such as heavy rain, snow,
etc., or if searching for a parking space that has
surfaces that will absorb the ultrasonic sensor
waves).
• New vehicles from the dealership must have at least
30 miles (48 km) accumulated before the
ParkSense Active Park Assist system is fully cali-
brated and performs accurately. This is due to the
system's dynamic vehicle calibration to improve the
performance of the feature. The system will also
continuously perform the dynamic vehicle calibra-
tion to account for differences such as over or
under inflated tires and new tires.
Enabling And Disabling The ParkSense Active
Park Assist System
The ParkSense Active Park Assist system can be en-
abled and disabled with the ParkSense Active Park
Assist switch, located on the switch panel below the
Uconnect display.
ParkSense Active Park Assist Switch Location
To enable the ParkSense Active Park Assist system,
push the ParkSense Active Park Assist switch once
(LED turns on).
To disable the ParkSense Active Park Assist system,
push the ParkSense Active Park Assist switch again
(LED turns off).
When the ParkSense Active Park Assist system is
enabled the "Active ParkSense Searching - Push OK
to Switch to Perpendicular" message will appear in the
instrument cluster display. You may switch to perpen-
dicular parking if you desire. Push the OK button on
the left side steering wheel switch to change your
parking space setting. You may switch back to parallel
parking if you desire.
Refer to your Owner's Manual at www.mopar.com/
en-us/care/owners-manual.html (U.S. Residents) or
www.owners.mopar.ca (Canada Residents) for further
details.
Advertisement
Table of Contents
