Fluke ScopeMeter 190-202 Service Manual page 57

Fluke 190-062, -102, -104, -202, -204, -502, -504
Service Manual
2. Select the Test Tool setup:
a) Recall the setup (see Standard Test Tool Setup). Press
b) Press
c) Press
d) Press
e) Press
f) Press
3. Press
the first test point in Table 4-3. Do this also for channel B, C, and D.
4. Set the 5502A to source the appropriate dc voltage.
5. Observe readings
under the appropriate column.
Due to calibrator noise, occasionally OL (overload) can be shown.
6. Continue through the test points.
7. When you are finished, set the 5502A to 0 (zero) Volt and Standby.
4-12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
( select
RECALL) and SETUP
press ENTER to recall the setup.
A
F4
, press
Attenuator: Normal | Bandwidth: 10 kHz or 20 kHz for the available setting in
the ScopeMeter.
B
, press F4
Attenuator: Normal | Bandwidth: 10 kHz or 20 kHz for the available setting in
the ScopeMeter.
C
, press F4
Attenuator: Normal | Bandwidth: 10 kHz or 20 kHz for the available setting in
the ScopeMeter.
D
F4
, press
Attenuator: Normal | Bandwidth: 10 kHz or 20 kHz for available setting in the
ScopeMeter.
CLEAR to clear the softkey menu and the full 8-divisions display.
mV
A
and use
RANGE
and
A, B, C,
. Press , select the setup name, and
ENTER
(
INPUT A OPTIONS...)
(
INPUT B OPTIONS...)
(
INPUT C OPTIONS...)
(
INPUT D OPTIONS...)
RANGE
and to set the Input A sensitivity range to
V
and check they are within the range shown
D
SAVE
F2
,
, and select
, and select
, and select
, and select