Advertisement
Available languages
Available languages
REMEMBER THAT THE LID MUST ALWAYS BE ATTACHED BEFORE THE BLENDER IS
ACTIVATED. LIKEWISE, IT IS RECOMMENDED THAT THE STOPPER IS ATTACHED
AGAIN BEFORE RE-ACTIVATING THE BLENDER!!
When crushing ice, do not process larger amounts at a time. It is recommended to start with
a maximum of 5-8 ice cubes. Pour a few tablespoons of water into the container before
activating the blender. Use the 'Pulse' setting until the desired result is reached.
Cleaning and maintenance
Container, lid, and stopper are rinsed in hot water with added mild detergent. Wipe all parts
thoroughly dry before storing the blender. The parts are not dishwasher safe. Do not use
scouring powder or other abrasive cleaners which may scratch or dull the surface. Any
hardened residue is removed after a brief soak with a mild detergent and a soft brush.
Use a moist cloth for cleaning the motor base. Allow the motor base to dry thoroughly before
the blender is used again or stored away.
IMPORTANT: THE MOTOR BASE MUST NEVER BE SUBMERGED IN ANY TYPE OF
LIQUID!!
Safety instructions
1.
Read the instructions carefully before use and keep the manual for future use.
2.
Only connect the unit to 230 Volt AC and only use the unit for its intended purpose.
3.
Always disconnect the plug from the power socket when irregularities occur during use,
after use, when attaching or detaching parts, and before cleaning and maintenance.
4.
The unit must never be submerged in water or other liquids.
5.
This unit is not intended to be operated by persons (including children) with limited
physical, sensory, or mental ability, or with little experience with or knowledge of the unit,
unless supervised or instructed in using the unit by a person who is responsible for their
safety.
6.
Children should be under supervision to ensure that they do not play with unit. Children
are not always capable of perceiving and assessing possible risks. Teach children to
handle electrical units with proper respect.
7.
Do not let the supply cord hang over the edge of the table.
8.
Never place the unit on or near hot plates, open fire, or similar.
9.
The unit should only be used under supervision.
10. Handle the unit with care as the blender blade is very sharp! Do not touch the blade
while it is in use. Keep fingers and tools away from the blade! Always disconnect the plug
from the power socket before cleaning the blade.
11. Always check unit, cord and power plug for damage before use. If the supply cord is
damaged, the manufacturer, the service agent, or a similar qualified person must
replace it in order to avoid hazard.
12. It is recommended that the unit is additionally protected according to power legislation
with a fault current protective device (RCD with a release current up to 30 mA). Contact
a licensed electrician.
13. The unit is for private household use only.
14. f the unit is used for other than the intended purpose, or used in violation of the
instruction manual, the buyer is entirely responsible for any consequences. Any resulting
damage to the unit will not be covered by the warranty.
21
Advertisement
