Restore Factory Settings; Online Guide And Video - VEVOR S3018 Manual

vigostick.local can still be opened to enter the web management interface. You can open About page of the controller
to check the IP address.
Network status: There is a dot in the upper left corner of the main page. The
hotspot is active, and the
interface is as previous page.
The web pages functions as follows:
Click the menu "Control", the MOVE Control interface appears, you can click the corresponding button to control the
CNC machine movement.
Click the menu "File", shows the carving files currently stored in the SD card of the current offline controller. You can
upload new files to the controller. After selecting the corresponding carving file to start the carving, the interface
displays the file being carved and the carving progress. You can click the button to pause or stop the carving process.
Click the menu "Settings", enter the carving machine setting interface, where you can set some control parameters, or
perform reset, unlock, restore settings, tools setting, turn on/off laser mode and other commands.
6.7 Laser Engraving App
The offline controller support mobile laser engraving App (For Android and iOS). Before using
the App, please turn on the laser mode in settings of the controller. Please get the VevorWorks
App form our website www.VevorEngraver.com
App supports Android and IOS. It can import mobile phone pictures, take photos with mobile
camera, edit graphics and text, generate engraving content, support gray, black and white,
contour and other engraving modes, and control engraving in real time.
7. FAQ
Q: How to use the lasers
A: 1. For XTS05/XTS08/XTS10/XTS15 laser, please place the material flat under the laser, and make the distance between
them within 3~10cm (Less distance will not be able to focus). Turn on the weak light, then there will be a light spot on
the material, just turn around the focus ring on laser to adjust the spot become smallest and clearest, which means the
best focus.
2. XTS15D laser is fixed focus laser which is not adjustable. The fixed focal Length is 18mm. Please use the focusing
column to determine the distance from the engraved object to the top surface of copper ring of light outlet.
Q: Laser module can't burn anything, no light, weak power.
A: 1. Please check power, speed setting on software and adjust focus length for laser [refer to 3.2 above to adjust focus].
Q: The picture engraved is the opposite of the original picture
A: Just need to adjust on software [ Reversal X/Y axis]
Q: The picture engraved distortion.
A: The screw rod and motor shaft are not locked and slipping.

8. Restore factory settings

If the mechanical movement of the machine is smooth, but the engraving movement appears stuck, or the stepper
motor does not move, please try to restore the factory settings of the main-board.
Method : Run Candle software and send command
9. Assembly video and online guide
Please scan the QR code below to watch the machine assembly video.
please scan the QR code to see how to download the software and related documents.
S3018 Ver 2.5
GREEN dot indicates that the controller has connected to Local WiFi. The web management
,or scan the right QR-code to download.
RED
$RST=* to the machine, then reboot the machine.
If the U disk in the machine kit can't be read,
14
14/
dot indicates that VIGO-STK****
Powered by VEVOR 2022