Danfoss iC7 Series Installation Manual page 10

In-bottom/Out-back Cooling Kit for FA11-FA12
Installation Guide
1
2
3
4
5
6
Illustration 8: Installation of Top Cover
1 M5x14 screw
2 Top cover
3 Top gasket
2.6 Assembling the Bottom Duct
The bottom duct is a telescopic duct that collapses to simplify installation. To assemble the duct before installation, use the follow-
ing steps. Refer to Illustration
Procedure
1. Cut the strip of ribbed EPDM rubber seal into 2 pieces of 990 mm (39.0 in).
2.
Peel the paper off the self-adhesive seals. Place 1 strip on the outside bottom edge of the inner sleeve of the duct, and
1 strip on the upper inside edge of the outer sleeve of the duct.
10 | Danfoss A/S © 2022.12
9.
4 Top vent
5 M5x12 screw (loosened, not removed)
6 Top of frequency converter
AN361429392581en-000201 / 136R0253
Installation