Setra Systems MRMS Installation Instructions

Multi-Room Monitoring Station (MRMS)
Installation Instructions
Setra's Multi-Room Monitoring Station (MRMS)
Setra's Multi-Room Monitoring Station (MRMS) is a remote environmental
condition monitoring and alarming solution for critical spaces in Healthcare,
Pharmaceutical, Biological Safety Labs and Vivarium. Using BACnet® MS/TP, the
MRMS can remotely monitor up to 8 spaces equipped with other Setra Pressure
and Condition Room Monitors (e.g. Model SRPM or SRCM). The MRMS can be
installed in a centralized location such as a Nurse's station or in a centralized
control. The MRMS user interface is simple, intuitive and allows the user to access
SRCM are then automatically imported into the MRMS resulting in substantial
installation and setup cost reduction.
1.0 INTENDED USE
The MRMS is designed to be used as a remote monitor of critical environments
by connecting up to 8 other SRPM or SRCM devices that provide local differential
pressure measurement/indication, temperature, humidity, and/or other parameters.
The condition status of the critical space as well as the measurement readings are
propagated to the MRMS through BACnet®. Typical applications include:
Healthcare – Hospital Nurse's Station
Pharmaceutical, semiconductor, precision manufacturing and other clean rooms
chemicals
1.1 SPECIFICATIONS
Operating Temperature Limits:
Operating Humidity Limits:
Supply Voltage:
Power Consumption:
Electrical Connection:
Housing:
Mounting:
Weight Approx.:
Agency Approval:
Communications:
1.2 MRMS FUNCTION
The MRMS communicates to other Setra Room Pressure Monitors (SRPM) and/or
information displayed on these remote devices. The MRMS visually indicate
humidity and door status.
User Interface:
resistive touch screen.
The home screen of the MRMS shows the name and status/condition of the rooms
being monitored remotely.
Color Status
Normal, Room Pressure is within alarm limits
Yellow
is within the alarm dead band.
Red Alarm. Room Pressure is outside alarm limits and alarm delay
Audible Feedback: The built-in audible buzzer will sound when differential
the remote SRPM or SRCM. Note that the buzzer will not sound at the MRMS
regardless of the volume setting if the audible alarm is disabled in the remote
2.0 PARTS AS SHIPPED
2.1 MRMS PARTS INCLUDED
Parts included in your order:
(Communications connector and power connector)
2.2 REQUIRED PARTS TO BE SUPPLIED BY INSTALLER
To mount and install properly, the following components are required:
recommended), as needed.
2.3 OVERVIEW OF PHYSICAL INSTALLATION
remote SRPM and SRCM devices, power supply, earth ground, etc.
connectors (provided). After the product is properly installed and
screen user interface.
device or negatively affects its performance.
Cleaning and Decontamination:
3.0 INSTALLATION
The MRMS is designed to be mounted in a standard triple gang-double deep
NOTE:
3.1 WIRING ELECTRICAL BOX (ROUGH-IN)
electrical codes.
inaccessible once the MRMS is installed. Strain relief tubing and wires, and seal
Tripe gang electrical box rough wiring and plumbing
3.2 BACNET WIRING
be used for communications ground and the shield wire can be connected to the
other device shield wires.
Connect shields together with wire nut.
right hand section of the PCB as well as through the touch screen interface.
Switch Position Function
Not Connected (Not Used)
3 Pull-Up Resistor
Termination Resistor
If the unit will be at the end of the line, the termination resistor can be enabled by