Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Setra Systems 761
Summary of Contents for Setra Systems 761
-
Page 1: Operating Instructions
MODEL 761 Absolute Capacitance Manometer OPERATING INSTRUCTIONS Toll Free: 800-257-3872 978-263-1400 159 Swanson Road, Boxborough, MA 01719-1304 Fax: 978-264-0292 Tel: 800-257-3872/978-263-1400, Fax 978-264-0292 sales@setra.com | www.setra.com Email: sales@setra.com, Web: www.setra.com... -
Page 2: Table Of Contents
8.0 Reordering Data ..................10 9.0 Returning Products for Repair ............10 10.0 Warranty & Limitation of Liability ..........11 11.0 FORM 761ERN - RETURN OF SETRA SYSTEMS SECTION 3: List of Substances in Contact with the Product SECTION 4: Return Information PRODUCT-DECLARATION ............... -
Page 3: Introduction
The Model 761 operates from a 13-30 VDC power supply and provides a 0-10 VDC or 0-5 VDC signal output that is linear with pressure and indepen- dent of gas composition. It is configured with a 15 pin D-Sub with “plug and play”... -
Page 4: Mechanical Installation
Setra Systems or your supplier immediately. Retain packaging materials call our Repair Department at 800-257-3872 (978-263-1400) for scheduling. for inspection. Do not use if damaged. If the Model 761 is not going to be used immediately, replace the protective flange cover and store in an 10.0 Warranty &... - Page 5 CONNECTOR 9.0 Returning the Model 761 for Repair Setra Systems cannot accept a Model 761 for repair unless the Form 761ERN is completed. Contact Setra Systems for an ERN Number or the Form 761ERN. Form 761ERN is included in this guide on page 15.
-
Page 6: Specifications
3. Units calibrated at nominal 20ºC Note 3: It is recommended that the 761 be powered with a linear power supply. 4. Wetted material is for 0.5” tube option only. Other flange options will add stainless steel. - Page 7 If the unit fails to operate when received or if the unit appears damaged, notify Setra Systems or your supplier immediately. Retain packaging materials for inspection. Do not use if damaged. If the Model 761 is not going to be used immediately then replace the protective flange cover and store in suitable conditions described in Section 2.
-
Page 8: Operation
If the unit was just received or stored at an extreme temperature, allow 12 of the Model 761. Adjust the signal output of the Model 761 to be 0.001 to hours for it to acclimate. It is recommended that the Model 761 zero output –0.001 V.
Need help?
Do you have a question about the 761 and is the answer not in the manual?
Questions and answers