Danfoss iC7 Series Installation Manual page 7

In-back/Out-back Cooling Kit for FK11/FB11 and FK12/FB12
Installation Guide
2.6 Attaching the Cabinet to the Pedestal
After installing the bottom cover, attach the pedestal to the frequency converter cabinet using the following steps.
Procedure
1. Lift the frequency converter and place it on the pedestal.
2. Slide 2 bolts at the rear of the pedestal into the 2 slotted holes on the rear of the cabinet.
Position the frequency converter by adjusting the bolts up or down.
3. Loosely fasten the frequency converter with 2 M10 nuts and locking brackets.
1
2
3
4
Illustration 5: Pedestal-to-Cabinet Back Mounting Points
1 Cabinet
2 Pedestal
3 M10 nut
4.
Loosely fasten the cabinet using 6 M10x30 bolts around the top of the pedestal.
Danfoss A/S © 2022.08
5
6
4 Slotted hole in cabinet
5 Bolt at rear of pedestal
6 Locking bracket
AN361429087579en-000101 / 136R0289 | 7
Installation