Unit For Amount Of Water; Restore Factory Settings - Jura IMPRESSA J9.3 Manual

Unit for amount of water

Restore factory settings

You can change the unit for the amount of water from 'ml' to 'oz'.
Example: Proceed as follows to change the unit for the amount of
water from 'ml' to 'oz'.
Precondition: 'Please select product:'
O T Press the P button.
'Maintenance status (1/6)'
g T Turn the Rotary Switch until the programme item
settings 1 (4/6)'
T Press the 'Units'
'Units'
T Press the 'oz'
T Press the
'Save'
'Saved' appears briefly on the display.
'Machine settings 1 (4/6)'
O T Press the P button to exit programming mode.
'Please select product:'
In the programme item
you can reset various settings to their factory settings:
U
'Machine'
U
All customer settings (apart from the 'filter') are reset to
factory settings. Your IMPRESSA then switches off.
U
'Products'
U
The settings (amount of water, aroma, temperature etc.) for
any product can be reset individually to the factory settings.
The corresponding double product is also reset to the fac-
tory settings at the same time.
U
'All products'
U
The settings (amount of water, aroma, temperature etc.) for
all products are reset to the factory settings.
U
'Display'
U
All display settings are reset to the factory settings.
Example: Proceed as follows to reset the values for
factory settings.
Precondition: 'Please select product:'
O T Press the P button.
'Maintenance status (1/6)'
4 Permanent settings in programming mode
is displayed.
is displayed.
button.
button.
button.
'Machine settings 1 (4/6)'
is displayed.
'Machine
/ 'Factory setting'
'Espresso' to the
29