Danfoss iC7 Series Installation Manual page 6

In-bottom/Out-top Cooling Kit for FA09-FA10
Installation Guide
16 (0.6)
6x Ø 6 (0.2)
Illustration 4: FA10 Rittal Cabinet Top Plate Template
2.4 Creating a Vent Opening in the Base Plate
To create a vent opening in the base plate for the bottom duct, use the following steps. Use the dimensions in
frequency converters, and Illustration 6
Procedure
1.
Cut out the vent opening in the cabinet base plate using the dimensions in the template.
2. Drill 6 screw holes (4 mm) around the vent opening using the dimensions in the template.
The holes must match the holes in the lower flange of the bottom duct.
6 | Danfoss A/S © 2022.03
323 (12.7)
291 (8.6)
56 (2.2)
180 (7.1)
for FA10 frequency converters.
Installation
8 (0.3)
128 (5.0) 138 (5.5)
17 (0.7)
Illustration 5 for FA09
AN371942791357en-000101 / 136R0254