Table of Contents
Advertisement
LAN1/2 Enable/Disable
Change the setting of jumper JPL1
to enable or disable the LAN1/LAN2
Ethernet ports on the serverboard.
See the table on the right for jumper
settings. The default setting is enabled.
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application hangs. Jumping pins 1-2
will cause WD to reset the system if
an application hangs. Jumping pins 2-3
will generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be
enabled in BIOS.
Note: When enabled, the user needs
to write their own application software
in order to disable the Watch Dog
Timer.
BMC Enable
Jumper JPB1 allows you to enable
the embedded Nutovon (Baseboard
Management) Controller to provide
I P M I 2 . 0 / K V M s u p p o r t o n t h e
serverboard. See the table on the
right for jumper settings.
I2C Bus to PCI-Exp. Slots
Jumpers JI
C1 and JI
2
to connect the System Management
Bus (I
C) to PCI-Express slots. The
2
default setting is Open to disable the
connection. See the table on the right
for jumper settings.
Chapter 5: Advanced Serverboard Setup
C2 allow you
2
5-23
LAN1/2 Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2
Enabled
Pins 2-3
Disabled
Watch Dog
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Reset
Pins 2-3
NMI
Open
Disabled
BMC Enable
Jumper Settings
Jumper Setting
Definition
Pins 1-2
BMC Enable
Pins 2-3
Normal (Default)
I
C to PCI-Exp
2
Jumper Settings
Jumper Setting
Definition
Closed
Enabled
Open
Disabled (Default)
Advertisement
Table of Contents
