NordicTrack NTL99520-INT.1 User Manual page 30

SYMPTOM: The displays of the console do not
function properly
a. Remove the key from the console and UNPLUG
THE POWER CORD. Next, remove the five #8 x
3/4" Screws (2), and carefully pivot off the Motor
Hood (65).
a
65
2
Next, locate the Reed Switch (108) and the Magnet
(107) on the left side of the Pulley (49). Turn the
Pulley until the Magnet is aligned with the Reed
Switch. Make sure that the gap between the
Magnet and the Reed Switch is about 1/8 in. (3
mm). If necessary, loosen the #8 x 3/4" Tek Screw
(14), move the Reed Switch slightly, and then
retighten the Tek Screw. Reattach the Motor Hood
(see above), and walk on the treadmill for a few
minutes to check for a correct speed reading.
Top
View
108
14
1/8 in.
b. If the console does not boot up properly, or
2
2
2
49
107
30
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all the cus-
tom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (C) on the back
edge of the console. Using a bent paper clip (D),
press and hold the reset button inside the opening,
and have a second person press the power switch
into the on (reset) position. Continue holding the
reset button (C) until the console turns on. When
the reset operation is complete, the console will
turn off and then turn back on. If it does not, use
the power switch to turn the treadmill off and then
on again. Once the console turns on, check for
firmware updates (see step 5 on page 25). Note: It
may take a few minutes for the console to be ready
for use.
b
C
D