Table of Contents
Advertisement
4.1.4
JTAG connector
The bottom side of the C214 board includes the footprint for a 10-pin 0.05" pitch JTAG connector
(J11), as shown in
UART connections, as shown in
Figure 14: JTAG Enable solder jumper and 10-pin JTAG footprint
Figure 15: JTAG connector (J11) pinout
☞
The JTAG connector is not mounted on the C14 board but can be added in the application design
– if needed.
UBX-22039292 - R01
C1-Public
Figure 14.
Four of these connectors are shared with the LTE as part of the 8-pin
Figure
15.
Module configuration
Page 19 of 28
Advertisement
Table of Contents
