Table of Contents
Advertisement
Page 168 of 532
Installing NT2K28AA displays on NTZK or NT2K sets
553-3001-367
Standard 1.00
Follow the steps in Procedure 31 to add an NT2K28AA display to M2008 and
M2616 telephones.
Procedure 31
Installing NT2K28AA displays on NTZK or NT2K sets
CAUTION WITH ESDS DEVICES
Before handling internal components of telephones,
discharge static electricity from hands and tools by
touching any grounded metal surface or conductor.
Opening the Telephone
1
Disconnect and remove all cords (including the handset) from the
telephone.
2
Place the telephone, upside-down, on a padded, level surface.
3
Using a #1 Phillips screwdriver, remove the two screws from the
footstand.
4
Carefully remove the footstand from the base. Press inward at the back
of the footstand where it meets the base and pull upward.
5
If the telephone has a Meridian Communications Adapter, unplug its cable
from the base telephone jack.
6
Loosen all screws on the base of the telephone.
7
Remove the base from the telephone.
Removing the Fillerplate
8
Loosen the screws that hold the fillerplate.
9
Remove the fillerplate, being careful not to touch the foam in the speaker
housing.
Attaching the Display Module
10 Position the Display Module as shown in Figure 47 on
October 2003
page
169.
Advertisement
Table of Contents
