Table of Contents
Advertisement
a Important
If the Automatic Datalog Download (GasAlertMicroClip
only) is enabled in Fleet Manager, data transfer
automatically begins during the purge. Do not remove
the detector until the DATA TRANSFER PASS LED
lights, otherwise the transfer will fail.
For more information, refer to
Download.
8. After the bump check is complete, the station
displays the results of the bump check and performs
a final purge to clear any remaining gas.
The countdown of seconds remaining displays
beside Purge.
Automatic Datalog
Bump Check Results
After the bump check is complete, the station displays the
results of the test.
Pass
Fail
_
H2S
Gas type not detected (H
example, this applies to all gases)
_
Sensor is disabled
After a bump check is performed, the GasAlertMicro,
GasAlertMicro 5, GasAlertMicro 5 PID, and
GasAlertMicroClip deactivate in 5 minutes if no activity is
detected.
Bump Pass
indicates that the bump test has passed. The detector is
now ready for use. Press C OK to return to the normal
operating screen.
MicroDock II
Bump Check
S is used as an
2
Note
57
Advertisement
Table of Contents
