How to Use the Base Station
a Warning
To prevent possible injury and/or property damage,
only use the station in an atmosphere that is clear of
hazardous gas.
Ensure that the station is attached to a venting system
or used in a well ventilated area.
The station pushbuttons are not labelled. The station is
operated by pressing the C pushbutton that is located
directly below the option that displays on the LCD.
Confirming Inlet Setup
a Warning
Failed tests can result if the inlets are not setup
correctly.
Before activating the station for the first time, ensure that the
gas cylinders are connected to the inlets correctly. Refer to
Installation. To confirm that the inlets are setup correctly,
refer to
Inlet Setup
in the
User Options Menu
Activating the Station
To activate the station, complete the following:
1.
Connect power to the station. Refer to Installation.
Self-Test
The station automatically performs a self-test during start-up.
Docking Module/Detector: The station checks for
connected docking modules and inserted detectors.
section.
The LCD displays information about the docking modules,
the model of the detector, and the detector serial number.
Press and hold C (the left most button) until the
2.
initializing screen displays.
The LCD immediately then displays the normal
operating screen.
MicroDock II
How to Use the Base Station
29