Table of Contents
Advertisement
The MicroDock II station can be easily mounted to a secure
surface. To mount the station, complete the following:
1.
Determine a secure location where the station is to
be mounted.
Using the screws that are provided, attach the wall
mounting plates to the station/docking modules.
2.
When the plates are mounted on the station,
measure horizontally on the wall the width of the
station; 2.38 in. (60.32 mm).
If two or more docking modules that are attached
together are being mounted on the wall, measure a
distance of 1.64 in. (41.7 mm) of space between
each docking module.
3.
Use four screws to attach the station to the secure
surface.
Changing Dip Switch Settings
(GasAlertClip Extreme only)
The GasAlertClip Extreme docking module provides the
option to change the gas type for bump checks by setting the
dipswitch within the docking module.
Table 14. Dip Switch Settings
Gas Type
Sulphur dioxide (SO
)
2
Oxygen (O
)
2
Hydrogen sulfide (H
S)
2
Carbon monoxide (CO)
MicroDock II
Changing Dip Switch Settings
Dip Switch Setting
25
Advertisement
Table of Contents
