Table of Contents
Advertisement
The station displays additional information regarding the
•
number of gas conflicts,
•
number of gases not found,
•
docking module (e.g., Bay 1),
•
detector gas type(s),
•
inlet, and
•
inlet gas type(s).
If a gas conflict is detected by the station, the gas select
screen automatically displays.
Refer to the following sections,
Before proceeding to resolve gas conflicts, refer to the
following section
Abort
Option.
Abort Option
The Abort option is located in the gas type column and is
used to quit the gas conflict function.
Conflicts
and
Not
Found.
If inlets have not been setup or are setup incorrectly, select
Abort to exit the bump check or calibration. Proceed to the
user options menu and select the Inlet Setup option.
To abort a gas conflict, complete the following:
From the gas conflicts screen, press C more. The
1.
conflicts/not found screen displays.
Press C
or C
2.
option.
3.
When the
displays beside Abort Test, press
C sel or press C OK. The station automatically
exits the gas conflict and returns to the normal
operating screen.
MicroDock II
Gas Conflicts
to scroll to the Abort Test
49
Advertisement
Table of Contents
