Operation; Setting The Mowing Height; Connecting To The Power Grid; Turning The Lawnmower On/Off - Fieldmann FZR 2028 E Manual

EN 12

Operation

6. OPERATION

6.1 SETTING THE MOWING HEIGHT

ATTENTION: Before setting the mowing height, always make sure that the lawnmower is turned off and
the blade is not moving.
ATTENTION: The blade will rotate several seconds after the lawnmower is turned off. A rotating blade may
cause injuries.
The mowing height is set in 3 positions independently on the front and rear wheel axle.
1. position 20 mm
2. position 40 mm
3. position 60 mm
Fig. 4.1
Setting the height of the front wheels - pull the wheel away from the grass catcher and select the desired
height. Follow this procedure for both front wheels. Figure 4. 1
Setting the height of the rear wheels - pull the wheel towards the grass catcher and select the desired height.
The height should be the same as on the front wheels. Follow this procedure for both rear wheels. Figure 4. 1
ATTENTION: Make sure that the height of all 4 wheels is set the same
Note: Lawns made up of standard grass blends should not be mowed to a height lower than 4 cm. Lawn
should not be shortened by more than 1/3 of its height.

6.2 CONNECTING TO THE POWER GRID

Insert the plug on the power cord into the power grid (230-240 V, 50 Hz).
Check that there is a suffi cient length of power cord available.
The length of the power cord should not exceed 30 m. The lawnmower may lose power when a longer power
cord is used.

6.3 TURNING THE LAWNMOWER ON/OFF

ATTENTION: Do not start the lawnmower when it is standing in a place with tall grass.
FZR 2028 E