Rheem 864 Series Owner's Manual And Installation Instructions page 23

bath fill water volume display panel – The selected bath fill water volume is displayed in litres on all Deluxe
controllers.
The selected bath fill water volume is displayed whenever the Bath Fill function is on
(refer to
adjusted and the Bath Fill function is off.
If the bath fill water volume is being adjusted and the Bath Fill function is off, then the
bath fill water volume display panel goes blank three (3) seconds after a BATH FILL
VOLUME button is last pressed.
At other times, if the Bath Fill function is off, the bath fill water volume display panel
remains blank.
bath fill indicator light – this light in the display panel will glow when the bath fill water volume is displayed.
BATH FILL TEMPERATURE up () button – The up () button increases the bath fill water temperature
setting (refer to
"Bath-Fill Function"
BATH FILL TEMPERATURE down () button – The down () button decreases the bath fill water
temperature setting (refer to
and to
BATH FILL VOLUME up () button – The up () button increases the bath fill water volume setting in
increments of 10 litres up to 500 litres. A further setting of 990 litres can be selected.
BATH FILL VOLUME down () button – The down () button decreases the bath fill water volume setting
from 990 litres to 500 litres and in increments of 10 litres from 500 litres down to 10 litres.
DELUXE CONTROLLER
bath fill water volume
display panel
bath fill
operating light
assistance call
button
bath fill
button
BATH FILL
VOLUME
up () button
BATH FILL
VOLUME
down () button
Deluxe controller type
K = Kitchen
B1 = Bathroom 1
B2 = Bathroom 2
"Bath-Fill Function"
"Temperature Adjustment – Deluxe Controllers"
on page 32).
"Temperature Adjustment – Deluxe Controllers"
"Bath-Fill Function"
on page 32).
operating bath fill PRIORITY
light indicator light
2 3 0
BATH (l)
BATH FILL
VOLUME
K
Bath Fill
1. 2. 3.
Bath Bath
Water Fill
Volume Temp
Set Bath Fill Press Bath
Water Volume Fill Button
and Temperature (Red light on)
Hot Water
1.
PRIORITY
Light on
Press
TEMPERATURE CONTROL – DELUXE
on page 32) or when the bath fill water volume is being
temperature
light display panel
PRIORITY
°C
4 2
BATH FILL
TEMPERATURE
4. 5. 6. 7.
Open Close
Bath Fill
hot tap hot tap
completed
(automatic)
Press Bath
Bath Fill Button Fill Button
(Red light flashes) (Red light off)
2. 3. 4.
Adjust
Open
Temperature
hot tap
23
on page 27 and to
on page 27
speaker
up ()
button
down ()
button
on / off
operating light
on / off
button
BATH FILL
TEMPERATURE
up () button
BATH FILL
TEMPERATURE
down () button
brief Deluxe controller
operating instructions
Bath Fill function and
Hot Water mode