Batteries And Charging - Sunrise Medical Sterling SAPPHIRE LS2 Owner's Manual

Off Board Battery Charger
Your scooter is supplied with an off-board charging
facility (Photo 12.1). Please note that only chargers
with a capacity of minimum 3.0 Amps and maximum
of 6.0 Amps supplied by your local authorised dealer
should be used.
1. Switch your scooter off at the key switch.
2. Swivel the charge connector cover located on the
Tiller Fascia Panel and connect the charger (Photo
12.2).
3. Ensure that the charger plug is dry and intact
before connecting it to the mains and switching
it on.
4. A reset button is located on the right-hand side of
the battery cover. Please check that the button is
pressed in (Photo 12.3).
Note:
The charger is capable of charging from 230V
or 110V by sliding the red tab on the end of the
charger to the required setting using a small
screwdriver. This setting is factory set to 230V.
The 5 Amp, off-board charger has 3 possible
indications (Photo 12.4):
1. RED = Charger is On.
2. YELLOW = Charging.
3. GREEN = Fully Charged.
Ensure the scooter is switched off before commencing
the charging process.
After charging, always swivel the charging socket
cover back into place. This helps prevent water getting
into the socket (Photo 12.5).
Please note that the scooter has a safety circuit to
prevent it from being driven off during charging. If
your scooter fails to respond to normal control after a
charging period, please check that the battery charger
has been completely disconnected from the scooter.

Batteries and charging

12
Photo 12.1
Photo 12.2
Photo 12.3
Photo 12.4
Photo 12.5
Iss 1.