Table of Contents
Advertisement
Choosing the
IMPORTANT!
location of third-
Refer to the manufacturer's documents for the suitable location for third-party
party batteries
batteries.
The inverter should be installed in a protected location, for ex-
ample, below the PV modules or under an overhanging roof.
The inverter must not be installed or used at altitudes above
4000 m.
4001 m
0 m
Do not install the inverter in:
-
Areas where it may be exposed to ammonia, corrosive
gases, acids or salts (e.g. fertiliser storage areas, vent open-
ings for livestock stables, chemical plants, tanneries, etc.)
During certain operating phases the inverter may produce a
slight noise. For this reason it should not be installed in an occu-
pied living area.
Do not install the inverter in:
-
Areas where there is an increased risk of accidents from
farm animals (horses, cattle, sheep, pigs, etc.)
-
Stables or adjoining areas
-
Storage areas for hay, straw, chaff, animal feed, fertilizers,
etc.
The inverter is designed to be dustproof (IP 66). In areas of high
dust accumulation, dust deposits may collect on the cooling
surfaces, and thus impair the thermal performance. Regular
cleaning is required in this case, see chapter
environments
on page 159. We therefore recommend not in-
stalling the device in areas and environments with high dust ac-
cumulation.
Do not install the inverter in:
-
Greenhouses
-
Storage or processing areas for fruit, vegetables or viticul-
ture products
-
Areas used in the preparation of grain, green fodder or an-
imal feeds
Operation in dusty
59
Advertisement
Table of Contents
