Removing The Smartcard Reader - Fujitsu FUTRO S930 Operating Manual

Removing the SmartCard reader

SmartCardreader
► Open the casing (see
► If a PCIe board is installed, you must remove the cross piece and PCIe
board (see "Removing the board", Page
► Disconnect the cable from the SmartCard reader (1) and from the mainboard (2).
► Undo the screws (3).
► Lift the SmartCard reader from the carrier (4).
► When required, reinstall the cross piece and the PCIe board (see
► Close the casing (see
Ensure that cables are not trapped between the casing and the components.
Fujitsu
"Opening the casing", Page
60).
2
"Closing the casing", Page
34).
3
4
1
"Installing the board", Page
62).
System expansions
3
58).
39