Checking The Hydraulic Fluid Level - Toro 22323G Operator's Manual

Checking the Hydraulic Fluid
Level
Service Interval: Every 25 hours
Hydraulic Tank Capacity: 12 US gallons (45.4 l)
Refer to Changing the Hydraulic Fluid (page 43) for hydraulic
fluid specifications.
Important: Always use the correct hydraulic fluid.
Unspecified fluids will damage the hydraulic system.
1. Remove the attachment, if one is installed; refer to
Removing an Attachment (page 24).
2. Park the traction unit on a level surface, lower the
loader arms, and fully retract the tilt cylinder.
3. Stop the engine, remove the key, and allow the engine
to cool.
4. Open the hood.
5. Clean the area around the filler neck of the hydraulic
tank (Figure 18).
Figure 18
1. Hydraulic filler neck cap
6. Remove the cap from the filler neck and check the fluid
level on the dipstick (Figure 19).
The fluid level should be between the marks on the
dipstick.
1. Filler neck
7. If the level is low, add enough fluid to raise it to the
proper level.
8. Install the cap on the filler neck.
9. Close the hood.
19
Figure 19
2. Dipstick