Compliance - OHAUS TD32PE Instruction Manual

EN-34
8.4

Compliance

Compliance to the following standards is indicated by the corresponding marking on the product.
Marking Standard
This product conforms to the EMC Directive 2004/108/EC and the Low Voltage Directive 2006/95/EC.
The complete Declaration of Conformity is available online at www.ohaus.com/ce.
Disposal
In conformance with the European Directive 2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE) this device may not be disposed of in domestic waste. This also applies to countries outside
the EU, per their specific requirements.
The Batteries Directive 2006/66/EC introduces new requirements from September 2008 on removabil-
ity of batteries from waste equipment in EU Member States. To comply with this Directive, this device
has been designed for safe removal of the batteries at end-of-life by a waste treatment facility.
Please dispose of this product in accordance with local regulations at the collecting point specified for
electrical and electronic equipment.
If you have any questions, please contact the responsible authority or the distributor from which you
purchased this device.
For disposal instructions in Europe, refer to www.ohaus.com/weee.
Should this device be passed on to other parties (for private or professional use), the content of this
regulation must also be related.
Thank you for your contribution to environmental protection.
For disposal instructions in Europe, refer to www.ohaus.com, choose your country then search for
FCC Note
WEEE.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
Thank you for your contribution to environmental protection.
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
FCC Note
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
following measures:
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
• Reorient or relocate the receiving antenna.
and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of
• Increase the separation between the equipment and receiver.
this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
interference at his own expense.
• Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Note
Industry Canada Note
This Class B digital apparatus complies with the Canadian ICES-003.
This Class A digital apparatus complies with the Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la Norme NMB-003 du Canada.
Cet appareil numérique de la classe A est conforme à la Norme NMB-003 du Canada.
ISO 9001 Registration
In 1994, Ohaus Corporation, USA, was awarded a certificate of registration to ISO 9001 by Bureau Veritus Quality International
(BVQI), confirming that the Ohaus quality management system is compliant with the ISO 9001 standard's requirements.
On May 21, 2009, Ohaus Corporation, USA, was re-registered to the ISO 9001:2008 standard.
3000 Series Indicators