Stop Bit; Handshake; Stable Only; Auto Print - OHAUS TD32PE Instruction Manual

3000 Series Indicators

3.8.4 Stop Bit

Set the number of stop bits.
1 = 1 stop bit.
2 = 2 stop bits.

3.8.5 Handshake

Set the flow control method.
NONE = no handshaking.
ON-OFF = XON/XOFF software handshaking.

3.8.6 Stable Only

Set the print critera.
OFF = values are printed immediately.
ON = values are only printed when the stability criteria are met.

3.8.7 Auto Print

Set the automatic printing functionality.
OFF = disabled.
ON.StAb = printing occurs each time the stability criteria are met.
INtEr = printing occurs at the defined interval.
CONt = printing occurs continuosly.
When INtEr is selected, set the Print Interval.
1 to 3600 (seconds)
3.8.8 Content
Select the additional content of the printout.
RESULT OFF = Result is not printed.
ON
NUM = Numeric portion of the displayed reading is printed.
GROSS OFF = Gross weight is not printed.
ON
NET OFF = Net weight is not printed.
ON
TARE OFF = Tare weight is not printed.
ON
UNIT OFF = Unit is not printed.
ON
MODE OFF = Mode is not printed.
ON
INFO OFF = Info is not printed.
ON
= Result weight is printed.
= Gross weight is printed.
= Net weight is printed.
= Tare weight is printed.
= Unit weight is printed.
= Mode is printed.
= Info is printed.
EN-23
rESULt
mMode
INFO