Table of Contents
Advertisement
EN-30
6.
LEGAL FOR TRADE
6.1
Settings
Enter the menu and perform a calibration as explained in Section 3 and then exit the Setup menu and power off the indicator.
Open the housing as explained in Section 2.3.1.
Set the position of the security switch, shown in Figure 1-2, to ON (item 4).
Close the housing.
NOTE: When the security switch is set to ON, the following menu settings cannot be changed:
Span Calibration, Linearity Calibration, Calibration Unit, GEO, Capacity, Graduation, Zero Range, Stable Range, AZT, Modes,
Units. To enable editing of these menu settings, return the security switch to the off position.
6.2
Verification
Before this product can be used in a trade approved application, it must be inspected in accordance with local weights and
measures regulations. It is the responsibility of the purchaser to ensure that all pertinent legal requirements are met. Please
contact your local weights and measures office for further details.
3000 Series Indicators
Advertisement
Table of Contents
