Troubleshooting Table; Repairs; Technical Data; Electric Lawnmower - Gardena 5031 D Operating Instructions Manual

Troubleshooting table

Problem
Engine does not start.
Engine is jammed and makes a
noise.
Loud noises, the mower is rattling. Screws on engine, its fixing or on the
Mower runs unevenly or vibrates
strongly.
Lawn is not cleanly cut.

Repairs

Note:
For any other malfunctions please contact the GARDENA
service department. Repairs must only be done by
GARDENA service departments or specialist dealers
approved by GARDENA .

Electric Lawnmower

Rated Power:
Mains voltage:
Mains frequency:
Speed of rotation cutting blade:
Cutting width:
32 - 001 -
Possible Cause
Extension cable is disconnected or da-
maged
Blade is blocked.
Blade is blocked.
Cutting height is too low.
mower chasing are losse.
Blade is damaged or the blade moun-
ting is released.
Blade is very dirty.
Blade is blunt or damaged.
Cutting height is too low.

Technical data

Unit
W
V
Hz
R/min.
cm
Remedy
Connect the extension cable or if ne-
cessary replace it.
Remove the obstacle.
Remove the obstacle.
Raise the cutting height.
Have screws tightened by an authori-
sed specialist dealer or the GARDENA
Service.
Have blade tightened or replaced by
an authorised specialist dealer or the
GARDENA Service.
Clean the mower (see Maintenance). If
this does not rectify the problem, con-
tact the GARDENA Service.
Have blade replaced by the GARDENA
Service.
Raise the cutting height.
Value (Art. 5031 )
1100
230
50
3400
32
25