Product Installation 1; Operation Instructions - Midea M7 Pro User Manual

PRODUCT INSTALLATION
Installation of Charging Base
1. Make sure the power cable is connected into the charging base.
2. Place the charging base flat against a wall and make sure there leaves enough space
to the base, as shown in the figure below.
EN
3. Ensure the charging base is connected to a power supply.
Installing the Side Brushes
1. Turn the unit over.
2. Attach the correct color side brush to the matching post and press down until they
fit into place.
3. Ensure side brushes can rotate freely.
13

OPERATION INSTRUCTIONS

Function of Buttons
Recharge Button
Network Pairing
Button
(under the cover)
Reset Button
(under the cover)
Start / Pause / Shut Down
Press and hold to turn on the robot.
Start: Short press button or use App to start cleaning.
Pause: Short press to pause the cleaning. To resume cleaning, briefly press again.
Shut Down:
Networking
Press and hold the network pairing button for network configuration. Robot is in pairing
status if the light is flashing.
Recharge
Short press button to recharge.
Reset
Press "Reset" button to reset the robot if it is not responding or does not
function properly.
Start / Pause / Shut Down
14
EN